Ham Radios - HF (some with VHF & UHF) - Icom 706MK2G HF VHF UHF radio IC-706MK2G (this is a "used item" - this model is no longer available brand new) - radios.net.au shop

This radio model has been discontinued and is no longer available brand new - we do however stock used versions of this radio on our Usded Equipment page here

The Icom IC-706MK2G is a compact HF/6m/2m/70cm all mode transceiver with built-in DSP. The radio has a backlit LCD display and features ARS, CTCSS tone encode/decode, 107 memory channels, and more. Supplied with a hand microphone with up and down frequency controls, and a fused DC power cord.

(UT-106 DSP BOARD IS INCLUDED AS A STANDARD INSTALL - BEWARE OF COMPETITORS SELLING THIS RADIO AT SLIGHTLY REDUCED PRICES BUT HAVE REMOVED THE $129 UT-106 DSP BOARD)

706 MkIIG Specifications

General

Frequency Coverage:
- Receive:
  0.030 - 199.999 MHz^*, 400 - 470 MHz^*
- Transmit:
  1.8 - 1.999 MHz^*
  3.5 - 3.999 MHz^*
  7.0 - 7.300 MHz^*
  10.1 - 10.150 MHz
  14.0 - 14.350 MHz
  18.068 - 18.168 MHz
  21.0 - 21.450 MHz
  24.89 - 24.990 MHz
  28.0 - 29.700 MHz
  50.0 - 54.000 MHz^*
  144.0 - 148.000 MHz^*
  430.0 - 450.000 MHz^*
  * Varies according to version
Mode: USB, LSB, CW, RTTY (FSK), AM, FM, WFM (Rx only)
Number of memory channels. : 107 (99 regular, 6 scan edges, 2 call channels)
Antenna connector : SO-239x2 (for HF/50 MHz and 144/430 MHz)/50 ohms
Power supply requirement: 13.8 V ± 15% (negative ground)
Frequency stability: Less than ± 7ppm from 1 min. to 60 min. after power ON. After that rate of stability less than ± 1 ppm/hr. at +25 ^°C (+77^°F). Temperature fluctuations 0^°C to +50^°C (+32^°F to +122^°F) less than ±5 ppm.
Current drain: Transmit max. power 20 A; Receive standby 1.8 A, max. audio 2.0 A
Usable temperature range : -10^°C to 60^°C (14^°F to140^°F)
Dimensions (projections not included):
- 167(W) X 58(H) X 200(D) mm
- 6-9/16(W) X 2-9/32(H) X 7-7/8(D) in
Weight: 2.45 kg (5 lb 6 oz)
CI-V connector: 2 conductor, 3.5 (d) mm (1/8")
ACC connector: 13 pin

Transmitter

Output power:

	SSB/CW/RTTY/FM	AM
HF/50 MHz	5 - 100 W	2 - 40 W
144 MHz	2.5 - 50 W	2 - 20 W
440 MHz	2 - 20 W	2 - 8 W

Modulation system:

SSB	Balanced modulation
AM	Low level modulation
FM	Variable reactance modulation

Spurious emissions: Less than -60 dB (below 47.5 MHz: -50dB; 47.5 - 50 MHz: -50 to -60 dB; above 50 MHz: -60 dB)
Carrier suppression: More than 40 dB
Unwanted sideband: More than 50 dB
Microphone connector: 8 pin modular jack (600 ohm KEY connector: 3-conductor 6.35 (d) mm (1/4")
RTTY connector: 3-conductor 3.5 (d) mm (1/8")

Receiver

Receive system:
- SSB/CW/AM/WFM: Double superheterodyne
- FM: Triple superheterodyne

Intermediate frequencies

	1st	2nd	3rd
SSB/AM-N/FM	69.0115 MHz	9.0115 MHz	455 kHz (FM only)
CW	69.0106 MHz	9.0106 MHz	-
RTTY	69.0105 MHz	9.0105 MHz	-
AM/FM-N	69.0100 MHz	9.0100 MHz	455 kHz (FM only)
WFM	70.7000 MHz	10.7000 MHz	-

Receive sensitivity (preamp on, except 4 - 4.5 and 8 - 9 MHz)

	SSB/CW 10 dB S/N	AM 10 dB S/N	FM 12 dB SINAD	WFM 12 dB SINAD
0.5 - 1.8 MHz	-	13 µV	-	-
1.8 - 28 MHz	0.15 µV	2.0 µV	-	-
28 - 29.7 MHz	0.15 µV	2.0 µV	0.5 µV	-
50 MHz band	0.12 µV	1.0 µV	0.25 µV	-
76 - 108 MHz	-	-	-	10.0 µV
144/440 MHz band	0.11 µV	1.0 µV	0.18 µV	-

Squelch Sensitivity (threshold)

SSB	Less than 5.6 µV
FM	Less than 0.3 µV

Selectivity (normal setting)

SSB, CW, RTTY	More than 2.4 kHz/- 6 dB
	Less than 4.8 kHz/ -60 dB
AM/FM-N	More than 8.0 kHz/-6 dB
	Less than 30 kHz/-36 dB
FM	More than 12 kHz/-6 dB
	Less than 30 kHz/-60 dB

Spurious and image rejection ratio:
- SSB/CW/AM - More than 70 dB
Audio output power (at 13.8 V DC): More than 2.0 W at 10% distortion with an 8-ohm load
RIT variable range +/-9.99 kHz
PHONES connector: 3-conductor, 3.5 (d) mm (1/8")/8 ohms
EXT SP connector: 2-conductor, 3.5 (d) mm (1/8")/8 ohms

Specifications are subject to change without notice or obligation.